pressure pipe

英 [ˈpreʃə(r) paɪp] 美 [ˈpreʃər paɪp]

压力管

化学



双语例句

  1. Check once again that the pressure pipe is seated securely.
    再次检查压力管是否牢固入位。
  2. Equipped with the steel water tank which is of high strength baking finish, stainless steel plunger ( SUS304) and pressure pipe with two moveable ends.
    配置有高强度烤漆钢板水箱,SUS304不锈钢活塞杆及双头均可活动的高压管。
  3. Disconnect the lower left pressure pipe.
    断开左下压力管。
  4. The brake oil pump is communicated with a hydraulic braking clamp through a high pressure pipe, and the hydraulic braking clamp is engaged with the brake disk.
    制动油泵通过高压油管与液压制动钳连通,液压制动钳与制动盘咬合。
  5. Finite Element and Fatigue Fracture Analysis of Tee Joints of High Pressure Pipe Joints
    高压管汇三通管件有限元及疲劳断裂分析
  6. It is particularly suitable for dual-pressure pneumatic system, which is precise energy-saving product required in high and low pressure pipe network optimization.
    特别适合于双压气动系统,是高低压管网优化必选的精细节能产品。
  7. Design and Application of Thrust Anchorage of Prestressed Concrete Cylinder Pressure Pipe
    预应力钢筒混凝土压力管止推装置的设计应用
  8. Asbestos-cement pressure pipe for gas transmission
    GB/T3040-1982石棉水泥输煤气管
  9. Instrumentation installation inf pressure pipe welding, should with medium of piping equally requirements.
    仪表安装中导压管的焊接,应与同介质的工艺管道同等要求。
  10. Pre-fit air cowl on pressure pipe.
    预安装压力管上的空气罩。
  11. Re-fit right boost pressure pipe.
    重新安装右侧的增压压力管。
  12. Analysis on the Operating Conditions and Material Requirments of the Pressure Pipe
    压力管道的工况分析及其对材料性能的要求
  13. Design of wire drive feeder in the high pressure pipe joints automatic welding system ( 1)
    高压管汇自动焊接系统&送丝机构设计(一)
  14. And abortion is the negative pressure pipe in the womb, the use of negative pressure suction to pregnancy product.
    而人工流产是将负压管放进宫腔内,利用负压吸去妊娠产物。
  15. Analysis of Installation Quality for the Pressure pipe Operation Safety
    安装质量对压力管道安全运行的影响分析
  16. Thereby, the piston structure can be arranged in an oil pressure pipe where gas and oil liquid are injected in advance to make reciprocating movement.
    藉此,该活塞构造可置入预注有气体及油液的油压管内行往复运动。
  17. The reflection of the disposal of the insufficient effective length of static pressure pipe pile in a new secondary school projects
    对某新建中学工程处理静压管桩有效桩长不足问题的反思
  18. Safety Assessment Method of Pressure Pipe with Volume Defects
    含体积缺陷压力管道安全评定的方法
  19. New Technique of High Pressure Pipe Snap Joints Used in Pipeline Connection of Anticorrosive Coating
    管道内防腐补口新技术&高压管道速接头
  20. Install pressure pipe with right pressure hose.
    安装压力管和右压力软管。
  21. Undo the hose clamp on the left pressure pipe and remove the entire overrun air valve module.
    松开左侧压力管上的软管卡箍并拆下整个溢流空气阀模块。
  22. Fatigue Test Analysis for Super-Large Bellow Pipe Used in Pressure Pipe for The Three Gorges Project
    三峡水利枢纽工程压力管道用超大型波纹管疲劳试验分析
  23. Disconnect pressure pipe from the charge air cooler.
    从中冷器断开压力管。
  24. To do so, undo the hose clamp and pull the hose off the pressure pipe.
    为此,松开软管卡箍并拉出压力管的软管。
  25. To do this, push the pressure hose onto the pressure pipe and tighten the hose clamp.
    为此,将压力软管推到压力管上并拧紧软管卡箍。
  26. Discussion on high strength prestressed concrete static pressure pipe pile construction
    试论高强预应力钢筋混凝土静压管桩施工
  27. Determination for the materials and diameter of a long pressure pipe plays an important role in the reasonableness and total cost of the power station.
    长压力管管材选取和管径的确定,关系着电站工程的合理性和总造价。
  28. Static loading tests and numerical analysis of the FLAC~ ( 3D) settlement about the static pressure pipe pile
    静压PHC管桩静载试验及FLAC~(3D)沉降数值分析
  29. Remove the boost pressure pipe.
    拆下增压压力管。
  30. Remove the Y-shaped pressure pipe.
    拆下y形压力管。